- Issue Time
- Apr 22,2022
Maintenance Manual of Retractable Grounding Reel
Retractable Grounding Reel (RGR)is designed to provide the lowest impedance connection between the shell of a floating roof tank and its roof by creating the shortest possible path between the two. This connection is obtained by keeping constant tension on the braided cable.
The RGR can be installed during erection, maintenance shut downs or during regular operation of a tank. It needs minimal maintenance and is easy to install on both new and existing tanks in petrochemical facilities
NOTE: All site safety policies and procedures must be followed.
permission must be obtained prior to any maintenance of equipment. While the
LEC recommends the activities outlined in this document, each site is unique
and must follow its own requirements, procedures, and protocols.
2.0 Maintenance Frequency
RGRs are often installed in corrosive environment. The more corrosive the environment, the more frequently inspection and maintenance must be performed. At a minimum, the following should be performed in an annual basis.
1. Remove build-up from RGR cable and reel.
2. Visually inspect the RGR cable for dirt, corrosion or tear; if there is a tear in the cable, replace immediately.
3. Ensure that all mounting base and bolts are mechanically tight. Tighten any loose hardware immediately.
Note: Never remove the reel from the mount if there is tension in the springs as the handles will rotate in an uncontrolled manner.
1 Spring 2 Axle 3 Horizontal Bracket 4 Mounting Base 5 Reel 6 Wire Guide 7 Ground Ends
8 Braided Cable
3.0 Equipment and Materials
Access to the RGR is very simple and can be inspected and maintained using common hand tools, as listed below. If permitted, photographs should be taken to document the condition and method of connection between each RGR reel and the tank top, as well as the connection of each ground strap to the foam dam or tank top.
Required inspection items
Digital multimeter (DMM)
adjustable wrench x 2
Wire wheel or brush
Sanchem Inc. NO-OX-ID “A-Special” or other electrically conductive lubricant
Lectra Shield or other electrically conductive corrosion inhibitor
4.0 Maintenance Process
4.1 Tank top inspection
4.1.1 Visually inspect the interface between the RGR bracket and the tank wall. During installation, paint and rust must be removed from all contact surfaces to ensure good contact. Contact surfaces should be sealed with a conductive corrosion inhibitor to provide a reliable electrical connection between the RGR bracket and the tank wall.
Use a digital multimeter (DMM) to measure the resistance between the RGR cable and the tank wall. Verify that there is no measurable resistance or measurement is less than 0.03 ohms.
4.1.2 Keep the reel clean.
4.1.3 Verify that the nuts and bolts securing the RGR are securely tightened.
If the main cable is torn or frayed, consult the factory for a replacement cable.
4.2 Ground straps
4.2.1 Confirm the connection of the two ground straps to the RGR main cable
4.2.2 Visually inspect the ground straps for dirt, buildup, corrosion or tears.
If the ground straps is torn or frayed, consult the factory for a replacement cable.
4.2.3 Visually inspect the interface between the ground strap and foam
Dam/floating roof connection point. During installation, paint and rust must be removed between all interface surfaces to ensure bare metal is exposed metal contact.
126.96.36.199 Use a digital multimeter (DMM) to measure the resistance between the RGR cable and the floating roof . Verify that there is no measurable resistance or measurement is less than 0.03 ohms.
4.2.4 As shown below in Figure 6, verify that all nuts and bolts connecting the RGR main cable to ground straps and ground straps to foam dam or floating roof connection point are securely tightened.
5.0 Technical Support
For technical support please contact:
Qingdao Alptec Safety Equipment Co., Ltd.
No.13 Hancheng Road, Qingdao Free Trade Zone, Shandong Province, 266555. P. R. China
Cell:+86 18766256959 | Tel:+86 (0) 532 8689 4009
Email:firstname.lastname@example.org | Skype: email@example.com | www.staticgrounding.cn