Anti-static grounding notes.

The metal sampler, calibration ruler, and temperature detector should be grounded via a conductive rope. In order to avoid rapid discharge, the resistance between the two ends of the sampling rope should be 10⁷~10⁹Ω.

The electrostatic grounding electrode resistance is required to be no more than 100Ω, and the contact resistance of the pipeline flange connection is no more than 10Ω. Notes and requirements for anti-static grounding:

Notes

Grounding is used to eliminate static electricity on conductors, but cannot be used to eliminate static electricity on insulators. Since an insulator with static electricity is directly grounded through a conductor, it is equivalent to directing the ground potential to the insulator, which will increase the risk of spark discharge, so the method of anti-static grounding is only suitable for conductors.

The anti-static grounding device can be shared with the work, protection and repeated grounding devices of electrical equipment. The ground connection wire should ensure sufficient mechanical strength and chemical stability. The connection should be reliable without any interruption. The anti-static grounding resistance value should usually not exceed 1MΩ.

The conductive ground is essentially a grounding measure. Using it can not only lead away the static electricity on the equipment, but also help to lead away the static electricity accumulated on the human body. Conductive ground often refers to ground such as concrete, conductive rubber ground, conductive synthetic resin, conductive wood, conductive terrazzo, and conductive ceramic tiles. When using conductive ground or conductive paint to spray the ground, the resistance between the ground and the ground should not exceed 1MΩ, and the contact area between the ground and the grounding conductor should not be less than 10cm².

In some dangerous places, in order to reliably ground the shaft, conductive lubricating oil can be used or slip rings and carbon brushes can be grounded.

In order to eliminate the static electricity of the human body, you can wear conductive work shoes (such as leather-soled shoes or conductive rubber-soled shoes), which is essentially a grounding measure. The resistance of conductive work shoes should be 10MΩ.